CWD
  • Conference for Wind Power Drives 2017
    Conference for Wind Power Drives 2017
  • Aufbau FVA-Gondel
    Aufbau FVA-Gondel
  • Conference for Wind Power Drives 2017
    Conference for Wind Power Drives 2017
  • Center for Wind power drives
    Center for Wind power drives
  • Conference for Wind Power Drives 2017
    Conference for Wind Power Drives 2017
  • Aufbau FVA-Gondel
    Aufbau FVA-Gondel
  • Vorstellung des 4MW Prüfstandes
    Vorstellung des 4MW Prüfstandes
  • 4MW-Prüfstand mit HybridDrive
    4MW-Prüfstand mit HybridDrive
  • 1MW-Prüfstand
    1MW-Prüfstand
  • Campus Melaten
    Campus Melaten

CWD open for registration now - Avail of our early bird offer!

The preliminary programme for the conference for Wind Power Drives is published here.

Registration for CWD 2019 is open now. Register now to avail of our early bird offer until December 16 2018. Click here for the submission website.

News

  • Plabed – Planetary Bearing Design

    As part of the Plabed project, which began in June, existing calculation models for mapping the load on planetary gear bearings will be improved and the loads on a test bench reproduced. The knowledge gained with regard to...[more]

  • 2nd CWD-Newsletter

    The last few weeks have been marked by the close cooperation of various disciplines along wind turbine drive trains at the CWD. Their efforts have paid off: the completion of the assembly of our flagship FVA nacelle project means...[more]

  • IEA Wind Task 35

    The CWD dedicated 6 and 7 June entirely to the IEA Wind Task 35. This workshop was visited by Professors Shuju Hu, Yangfeng Meng and Ya Deng from the Chinese Academy of Science, Beijing. Part of the task involved investigating...[more]

  • FVA Nacelle - Start of the test procedure

    This week the test procedure of the FVA-Nacelle has started. Within the next weeks over 200 sensors will be applied to the Nacelle. The hardwae in the loop operation will start soon. Thanks to all employees who have made it...[more]

  • Toleranzfeldbasierte Auslegung der Verzahnungen des Getriebes in der FVA-Gondel

    Die Verzahnungen im Getriebe der FVA-Gondel des CWD wurden mithilfe einer am Werkzeugmaschinenlabor (WZL) entwickelten toleranzfeldbasierten Auslegungs- strategie für Zahnräder konzipiert. In einem solchen Prozess werden zunächst...[more]

  • Gearbox Assembly

    Whtin in the last week the gearbox with the main shaft was assembled to the FVA nacelle. The CWD-team precisly placed and mounted the 55 tons assembly with a tilt angle of 6° on the nacelle. Now the test bench can be put into...[more]

  • Displaying results ###SPAN_BEGIN###%s to %s out of ###SPAN_BEGIN###%s